I will show tips and tricks for printing thin wall with this Artillery Sidewinder direct drive printer. I also print a full 3D printed RC airplane and give a review on the process.
Thank you so much for watching!
*These are the settings I used for this Artillery Sidewinder X1 with Overture PETG. These may not work exactly for you, but should give you a good base to start with if you have a similar size printer. Good luck!
Profile 3 Cura Settings:
Quality:
Layer Height – 0.25
Line Width – 0.4
Shell:
Wall Line Count – 1
Infill:
Infill Density – 0
Material:
Printing Temperature – 240
Build Plate Temperature – 60
Flow – 100
Enable Retraction – Checked
Retraction Distance – 1.3
Retraction Speed – 10
Retraction Extra Prime Amount – 0.2
Speed:
Print Speed – 100
Outer Wall Speed – 35
Inner Wall Speed – 35
Travel Speed – 100
Travel:
Combing Mode – off
Cooling:
Enable Print Cooling – Checked
Fan Speed – 50
Mesh Fixes:
Union Overlapping Volumes – NOT Checked
Special Modes:
Surface Mode – Surface
Experimental:
Slicing Tolerance – Middle
Hey guys, in this video you will see how to make a professional look RC transmitter using Arduino Uno and NRF24L01 that can be used to control your RC plane, boat, quadcopter, and other applications
