For this video I need supper glue, cardboard, old car`s wheel, Iron wire, Push Pins Drawing Cork Board, small screws (if you want to remove the plane part you have to use a small screw
Justin skimmed over a small but important step! The GoPro power cable needs to be soldered into the 5 volt power source going into the FPV video transmitter on the drone
The first step is gathering the matirials 1x 80cm andd 18mm by 18mm wide strong andd stiff wooden stick then you need a 5cm wide 35cm long multiplex board cut in 3 ddifferent lengths 2 times 5 by...
