Free plans for RC Flying Wing

RC store

Rewiev:

Plane specifications:
- Wingspan — 95cm
- Root chord — 16.3cm
- Tip chord — 11.5cm
- Sweep angle — 15 degrees
- Dry weight (no battery) — 468g
- Flying weight — 670g
The CG position is marked on the bottom of the fuselage with 2 circle cut outs.
General Print settings
- Material — PLA (1.75mm)
- Nozzle diameter — 0.4mm
- Wall thickness — 0.5mm
- Layer height — 0.2mm
Print settings for the wing sections:
- Temperature — 215 degrees Celcius
- Print speed — 25-30mm/s
- Cooling fan — off
- Infill — 0%
- Top layers — 0
- Bottom layers — 1 (for bed adhesion)
- Outer layers — 1
Print settings for other parts:
- Temperature — 200 degrees Celcuis
- Print speed — 60mm/s
- Cooling fan — on
- Infill — 15%
- Top layers — 3
- Bottom layers — 3
- Outer layers — 2
Electronics
- ESC (x1):
- 5V Regulator (x1) — http://bit.ly/2Df1Vdj
- Servos (x2) — http://bit.ly/2gqRdZM
- Motor (x1): — http://bit.ly/2vRL5gU
- Battery (x1) — http://bit.ly/2hiQnLN
Other parts:
- Propeller (x1) — http://bit.ly/2DgyeZx
- Glue (x1) — http://bit.ly/2Dfs3EU
- Canopy Magnets (x1 set of 100pcs)- http://bit.ly/2DgymrZ