This wings is designed using TinkerCAD. The purpose is to use them for a micro RC flying wing.
The assembled wing is 40cm (400mm). I was able to print each wing diagonally on my Monoprice Maker Select 3d v2.1 printer that has a 200mm build plate. I covered the wings with packing tape and used foam plates to cut out winglets that I drew freehand.
The CG is just behind the box that holds the receiver brick.
Print Settings
Printer: Monoprice Maker Select v2.1
Rafts: No
Supports: No
Resolution: .2
Infill: 5%
Printed with 2 walls (.4mm) and ZERO top and bottom layers. For infill I used a grid pattern in Cura. This is what generates the wing structure.The wings should be oriented on the plate the same for each wing, though a reverse orientations should be fine too. This helps the grids to line up when assembling the wings.
Electronic:
Racerstar Racing Edition 1306 Buy: 2 Pairs Gemfan 3035 Buy: SimonK Series 12A ESC Buy: Power HD-1370A 0.6KG 3.7g Buy: 3.7g Micro Mini Servo Buy: Giant Power 2S 7.4V Buy: ZOP Power 7.4V 400mAh Buy:
Heres the unboxing and overview of the ZOHD Dart 250G, I have got the FPV PnP version here, with FPV camera & Kopilot Autopilot and very much look forward to putting it together
