The last cartoon RC plane had surprisingly very good feedback from my audience, so I make another model. This time is Mig-21 Lancer in fatty or cartoon style. The original plans was making Spitfire, but change to Mig-21 because it won the poll on my channel`s community tab. This Mig-21 is looks huge with 105 cm wingspan but only weight 1050 grams. It uses the same electronic as T-2 Buckeye. It has detachable landing gears, so you can switch mode easily on field, you can choose to take of run with wheels from ground or just tossing the plane into the air.
You can download the plans on the link below :
Playlist :
02:21 Plans Preparation
03:41 Wing
08:52 Fuselage
17:19 Stabilizer
20:08 Canopy
22:47 Elevator Servo u0026 Motor
26:40 Landing Gear
28:43 Covering
32:05 Paint u0026 Decal
35:22 Battery Tray
37:55 Maiden Flight
45:26 Review u0026 Next Model?
Specs :
1. Wingspan 1050 mm
2. Flying weight : 1170 grams/ 41.3 oz
3. Wing loading : 37.7 g/dm2 - 12.4 oz/sq.ft
4. Wing cube loading : 6.8
5. Wing Area : 31 dm2 / 481 sq.in
6. CG 31 cm from TE
Materials :
1. 3 mm Depron/ Polyfoam
2. 5 mm Depron/ Polyfoam
3. 7 mm Plywood
4. Hot glue, CA glue, PVA glue
5. 3 mm, 2.5 mm bicycle wheel spoke wire
6. 1.5 mm wire
7. white packing tape / wax paper
8. Bamboo chopstick
9. 0.3, 0.5 mm Mica plastic
Ok, so I am going to take one last jaunt into the 3D printing arena here in association with Eclipson Airplanes regarding finding the best material to print your aircraft
