JOE 3D PRINTED ALL THE MODELS IN THESE PHOTOS HIMSELF IN HIS OWN MACHINE AT HOME,
THE MIG MAIDENED VERY WELL IN THE GUSTING 15 MPH WIND BUT DUE TO THE BRITTLE NATURE OF THE PLASTIC SHE SIMPLY BROKE UP ON THE SLIGHTLY HARD LANDING - PITY AS THERE IS POTENTIAL THERE !
There was a stiff breeze today at the field and a lot of thermal turbulence so I thought I`d see how well the little DIY Sub-250 gram FPV model I built from foamboard would handle the conditions
The first step is gathering the matirials 1x 80cm andd 18mm by 18mm wide strong andd stiff wooden stick then you need a 5cm wide 35cm long multiplex board cut in 3 ddifferent lengths 2 times 5 by...