How To Make Twin Motor RC Model Airplane - DIY Brushless Motor Model Airplane.
How to make 2 brushless motorized remote controlled aircraft from foam board material.
INFORMATION: The Foamboard is made of foam and the outside is paper-covered. It is lightweight, robust and easy to cut. Easily bonded with hot silicone.
2 pieces of brushless motor 2205 1800-2600KV. (2204 can also be)
2 pieces of 6x4 or 5x4.5 propellers (CW & CCW)
30A Brushless ESC (35-40A can be used according to the motors you will use)
11.1V 1300Mah LiPo battery
3pcs 35-40mm wheel
2 mm spring steel wire (for landing gear)
1.2 mm spring steel wire (for pushros & control rods)
4 pieces horns
4 or 6 channel radio control system
4 micro servos (may be 9gr servos)
Gold Connectors 3.5mm (for Y cable)
Wheel stopper
Technicial Specifications:
Lenght: 60 cm
Wing span: 87 cm
Flight weight: About 715 g
Center of gravity: 4-4.5 cm from the front of the wing
Required control system: 4 channels, 4 micro servos
Suitable battery: 11.1V 1300Mah - 1600Mah Lipo battery
Suitable motor: 2205 - 2204 (1800-2400KV)
Suitable propeller: 5x4.5 - 6x4
This time I`m going to teach you how to make modifications to the RC airplane to make it fly faster and better, but you`ll need some time and dedication to complete this project
