How To Make RC Model Airplane Fun-Fly Style. DIY RC Airplane With Brushless motor
Plans for this airplane:
How to make slow flying and acrobatic fun fly sytle RC airplane.
The Fun-Fly model aircraft can fly at very low speeds. It can maneuver in short distance and perform acrobatic maneuvers in series. Very short distance is enough for take off.
INFORMATION: The Foamboard is made of foam and the outside is paper-covered. It is lightweight, robust and easy to cut. Easily bonded with hot silicone.
Necessary Materials:
2205 2000-2600KV Brushless Motor:
6x4 propellers:
OR
30A Brushless ESC (20-25A can be used according to the motors you will use):
11.1V 1000Mah or 1100-1300Mah LiPo battery (3S):
2pcs 35-40mm Wheel:
Pushrods:
2mm Rod For Landing Gear:
4 pieces horns:
4 or 6 channel radio control system:
4 micro servos (may be 9gr servos):
Gold Connectors 3.5mm (Motor & ESC connections):
Wheel stopper:
Y extension cable:
L type nylon clevis keper clip:
Adjustable Linkage stopper (Easy Link):
Lipo Battery Charger:
5mm kraft foam board (50x70 plate):
Hot melt Glue Gun:
Technicial Specifications:
Lenght: 680 mm
Wing span: 665mm
Flight weight: About 490 g
Center of gravity: 5.5-6 cm from the front of the wing
Required control system: Min. 4 channels, 4 micro servos
Suitable battery: 11.1V 1000Mah - 1300Mah Lipo battery
Suitable motor: 2205 Brushless (2000-2600KV)
Suitable propeller: 2 Blade 6x4 or 3 Blde 5x4.5
We set out on a crazy quest to convert our mini quadcopter into a remote control airplane using only two sheets of paper and scotch tape! The Amazing Pink Mini Quadcopter:
