After I already build several historic airplanes in usual construction I wanted to design a fully printed model.
I thought about something that looks similar like a Fokker.
The problem of this kind of shape is the short nose of the fuselage because it makes the plane tail heavy. That means the tail must be very light.
My idea was to cover the tail unit with a printed coat of 0.2 mm. And the rear fuselage should be an open half-timbered construction for additional saving weight.
I made this in cooperation with “Wersy” who has taken the part of the wing. He spend a lot of effort to shape the surface wave-like to give it a natural look.
So it looks as if the wing is covered with fabric.
Specifications
airfoil: ClarkY modified
wing span: 1550 mm
wing chord: 285 mm
aerodynamic center:
overall weight: 3500 g
wing weight complet:
fuselage weight complet
wing area: 44,18 dm²
wing loading: 75 g/dm²
Electronic:
DYS D3548 3548 790KV Buy: Surpass Hobby C3548 790KV Buy: Hobbywing Skywalker 2-6S 80A Buy: V-Good IONX 32 Bit Buy: 4X JX PDI-6221MG 20KG Buy: MG995 High Torgue Metal Buy: MG996R Metal Gear Digital Buy: ZOP Power 4S 14.8V Buy: ZOP Power 14.8V 4000mAh Buy: 1pc KMP 1280 12X8E Buy: 1pc KMP 1280 12X8E Buy:
For this video I need supper glue, cardboard, old car`s wheel, Iron wire, Push Pins Drawing Cork Board, small screws (if you want to remove the plane part you have to use a small screw
![[Tutorial] DIY - How To Make Airplane J3 Cub MINI RC](/images/photos/small/article223.jpg)
