|
- Rewiev:
Madame Jeanette is a very fast pylon racer, use a 3 cell battery for fast flying, use 4 cell battery for extreme flying.
Designed for Lightweight PLA, strong construction, and still about the same weight as a traditional wooden airplane. 
Spec.
Wingspan: 720mm
Weight: 420 to 500 gram
Control throws: elevator:3mm up and down
Ailerons: 6mm up and 3mm down.
Minimum print area 220x220x250mm 
Cura printer settings:
LWPLA
To prevent stringing, print only one part at a time.
Use Cura std quality 0,2 as a start setting, modify with:
Layer height: 0,2mm
Line width: 0,4mm
Wall line count: 1
Z seam alignment: User specified, back
Top/bottom layers: 3
Infill: Gyroid, 4mm line distance
Printing temperature: 235, build plate temperature: 60, Flow 55%
Speed: 40mm/s
No support
Build plate adhesion: Brim 3mm
PLA (P1)
Use Cura std quality 0,2 as a start setting, modify with:
Layer height: 0,2mm
Line width: 0,4mm
Wall line count: 1
Z seam alignment: User specified, back
Top/bottom layers: 4
Infill: Gyroid, 3mm line distance
Printing temperature: 215, build plate temperature: 50
Speed: 40mm/s
No support
Build plate adhesion: Brim 3mm
PLA (P2)
Use Cura std quality 0,2 as a start setting, modify with:
Layer height: 0,2mm
Line width: 0,4mm
Wall line count: 4
Top/bottom layers: 4
Infill: Grid, 100%
Printing temperature: 215, build plate temperature: 50
Speed: 40mm/s
No support
Build plate adhesion: skirt 3mm 
Electronics:
|
