In this video, I make a custom PCB with electronics to control LED lights and handle servo mixing and gyro stabilization on a model airplane. A Teensy 32 bit Arduino compatible microcontroller is used to read an SBUS-signal from an RC receiver and make ten servo signals. Each servo signal can be mixed with any input signal and any gyro axis. The LEDs are powered using MOSFETs the can supply several amps per channel. The board also has two redundant power inputs. If one fails, everything will continue to work.
RC Airliner meeting Germany Turbine Model Airplane with engine failure duringe the Takeoff and preparation the Model Airliner Huge RC Airplane and a Sad ending for a Airbus A-330 Air Berlin last...
