How to make an RC Plane SPAD - ( by Rahul Arya & Aidren Quental )

This is an attempt to make a small video on:
How to make an RC Plane at home in low budget, with minimal requirements.

This is an attempt of small tutorial demo.
Materials Used:
1. Corrugated plastic (coroplast) / depron / styrene / blue foam sheets 2-3mm
2. Araldite klear 5min epoxy / hot glue
3. 0.5mm steel rods (push rods/landing gear)
4. 3mm plywood for motor mount/firewall
5. velcro
6. Duct tape, double sided foam tape
7. Aluminum C channel / 3mm carbon rod / 3mm plywood - for wing spar.
8. Lipo battery, speed controller, BLDC motor, propeller, 4 mini servos
9. RC 4-6 channel transmitter~receiver.

Similar articles:

"How To" Video → How to make quadcopter at home very easy By RK

"How To" Video → how to fiberglass a RC airplane

"How To" Video → DIY Own RC Airliner Engine Nacelles!

"How To" Video → How To make a canopy

"How To" Video → Making an RC airplane canopy (without a vacuum former)

How to make a TURBORAMJET engine, full build!