3D PRINTED RC ROCKET CHALLENGE w. JAMES BRUTON | PT.1
Yessss!! I`m doing a rocket challenge with the very same James Bruton!
We set ourselves to design and build two 3D printed RC rockets that could vertically take of and land using EDFs using two different design approaches. In this video you can see how I choose to pull the rocket from the top and how I tried to use a heli gyro to avoid the torque rotation of the main EDF. I implemented translation capabilities through my RC remote so don`t forget to tune in next week on both channels to see how the rockets perform on the wild.
The BushMule is back! Stuart goes going over all the changes in V2 in this official flight review! Learn about its history, what`s new with the Avios PNF BushMule V2 Twin-Motor Sports/STOL Airplane...
