Correx Wing Build. How to build a correx wing with a single sheet of correx. I used a 120cm x 60cm piece which I then cut down to 120 x 35cm.
The 35 cm consists of 15cm for the lower surface, 1cm for the leading edge fold plus another 15cm for the upper surface and finally 4cm for the control surfaces/ailerons.
I purchased the sheet from a local hardware store for around R50 ($3) Tools required: cutting blade hot glue gun ruler/straight edge carbon fibre wing spar(not vital) #
Une nouvelle revue de ce E58 , aussi vendu sous plein d`autres marques , toujours aussi correct en vol , il est un peu obsolete maintenant , on regrette que Eachine n`est pas sorti une version gps
THE MIG MAIDENED VERY WELL IN THE GUSTING 15 MPH WIND BUT DUE TO THE BRITTLE NATURE OF THE PLASTIC SHE SIMPLY BROKE UP ON THE SLIGHTLY HARD LANDING - PITY AS THERE IS POTENTIAL THERE !
