In today`s video I 3d printed a radio controlled boat using the Creality CR-10s 3d printer. The boat was printed in 5 body sections and an additional 3 hatch sections. I glued the part together using epoxy that seemed to work fairly well, though you really need to install some reinforcement brackets in order to have a solid construction.
The boat is powered by a massive brushless motor (2650kv), that I salvaged from one of my RC cars. With a 120A electric speed controller and a 4S 6Ah battery (16V), it would have all the power in the world!
RC boat STL file:
Almost immediately after testing the boat for the first time I noticed several major flaws. The 5 body sections is only held together by glue, you would greatly benefit with some cross-going spars that would reinforce the structure. As I explained in the video, even though it was no immediate leakage, the water creeps through the PLA. It has mostly likely something to do with the settings used to print all the sections.
There were also a situation with the propeller surfacing too much and not pushing the boat forward. It was unclear if the boat was too heavy or too light and the glue was less than optimal in water.
To be continued...
Music:
Beautiful Cinematic Music - Beyond
Blue Wednesday - Need You Around
Liam.M - I Dont Need It
MGR 7TH - In A Lifetime
Eachine sort des drones tous les mois , avec celui ci ils avancent un peu niveau qualité video , mais toujours pas au top niveau application , (mise à jour et amelioration...
Bagaimana kemampuan drone berikut saya coba tampilkan melalui video ini mudah-mudahan dengan vido ini bisa dijadikan gambaran bagaiamana sebenarnya kelebihan dan kekurangan drone tersebut sehingga...
