Maripi is easy to fly airplane designed for acrobatics training and simply having fun in the air.
The wings have couple important improvements over Kodo. Most significant change is new leading edge design. Thanks to that the airfoil shape is more exact. The airflow is laminar on bigger part of the wing and the plane behaves more true to the aerodynamic simulations.
The wing is also lighter due to the thinner mesh with bigger spacing.
The fuselage is also a new design to make sure it is printable on wide range of 3D printers and as light as possible.
Specification:
wingspan: 110.3 cm
length: 98.5 cm
ready to fly weight: 1005 g
wing area: 0.19 m2
motor size: ⌀ up to 35 mm
required RC: 5 channel
printer build volume: 15 x 15 x 10 cm
printing material: irrelevant
weight of printed parts: 524 g
parts count: 66
printing time: 82 h - 92 h
For this video I need supper glue, cardboard, old car`s wheel, Iron wire, Push Pins Drawing Cork Board, small screws (if you want to remove the plane part you have to use a small screw
