Free plans for Letov S.239



  • Rewiev:

    plans rc airplane Letov S.239 (scale)

    1. Linden 4x4mm rail section — 6 pcs. + Front edge of asymmetrical 7h12 — 1m
    2. Balsa 2.5mm — 2 pages
    3. Balsa 4mm — 0.5 page
    4. Balsa 6mm — used to trim
    5. Balsa 10mm — 2 small pruning in the wingtips. It is possible to replace polystyrene foam.
    6. Balsa 1mm — 2.5 sheet
    7. The covering film silver (white) and purple (red) — just did not measure, but there is still a lot of rolls.
    8. The wire cross-section 1.5mm chassis and synchronizer PB — a little less than a meter.
    9. Plastic landing gear was selected in the store, "Wright Brothers" in weight and size of some or microhelicopter copter. 4 pieces — set used alone.
    10. Wheels chassis front and rear.
    11. Loop in ailerons — 5 pieces.
    12. The hinges in the tail — 6pc.
    13. pig — 4 pcs.
    14. Catches wheels — 3pc.
    15. Traction — 3pc.
    16. Screw 8x4
    17. Catches rods.

    plans rc airplane Letov S.239 (scale)

    plans rc airplane Letov S.239 (scale)

    plans rc airplane Letov S.239 (scale)

    plans rc airplane Letov S.239 (scale)

    plans rc airplane Letov S.239 (scale)


    Electronics:
    1. Motor Turnigy 2730-1500
    2. Servo HK-S0361
    3. Receiver Spectrum ARP6210 only satellite unbuckled unnecessary.
    4. Regulator Turnigy Plush 12A
    5. The batteries or 2S 500mah 850mah
    6. The wire (about 1m) and connectors.

    plans rc airplane Letov S.239 (scale)

Rating: 5 Votes: 1 Your vote:
Comments (0)

No comments yet. Yours will be the first!

How to make video

COMPRANDO HARDWARE BARATO

RC Plane Poster  0  1520
Hola como están todos! Hoy les traigo el unboxing de el primer paquete en llegar del año con algunas compras en EBAY y algunos regalos de BANGGOOD para hacer unas review en el canal

 


How to land 3D printed plane in snow

RC Plane Poster  0  2158
I`m getting millions of requests every day asking me how to land a 3D printed RC plane in snow

 


KF101 GPS 4K Drone - Full Review

RC Plane Poster  0  1242

 


3D PRINTED RC ROCKET CHALLENGE w. JAMES BRUTON | PT.1

RC Plane Poster  0  1971
Yessss!! I`m doing a rocket challenge with the very same James Bruton!

 


MN-90 Crawler Monster Truck Full Review!

RC Plane Poster  0  1505
MN-90 Crawler Monster Truck Full Review! Unboxing !

 


New RC airplane from scratch by RAMY RC

RC Plane Poster  0  2712
Designing and building new RC airplane from scratch by RAMY RC

 


Rc plane build, homemade 3 channel glider build (DIY)

RC Plane Poster  0  1665
its easy to build using foamboard its a 3 channel remote controll rc plane a verystable plane good for biggeners

 


RC J11 Airplane Unbox and Flying

RC Plane Poster  0  1700
Review RC J11 Airplane (RC Sea Plane)